Articles
- Introduction
- New Project
- Open Project
- Save Project
- Delete Project
- Upload DXF
- New Joint
- Delete Joint
- Edit Joint
- List Joint
- New Member
- Delete Member
- Edit Member
- List Member
- New Joint Load
- Delete Joint Load
- Edit Joint Load
- New U.D. Load
- Delete U.D. Load
- Edit U.D. Load
- List U.D. Load
- New Slab
- Delete Slab
- Edit Slab
- List Slab
- Joint Renumber X
- Joint Renumber Y
- Joint Renumber Z
- Help
- Tutor
- Zoom Window
- Zoom All
- Default Member Size
- Default Member Load
- Joint Offset Y
- Joint Offset Right
- Joint Offset Down
- Joint Offset Left
- Joint Offset Up
- New Support
- Delete Support
- Edit Support
- List Support
- New Point Load
- Delete Point Load
- Edit Point Load
- List Point Load
- New U.I. Load
- Delete U.I. Load
- Edit U.I. Load
- List U.I. Load
- Copy Entire Floor
- Run Analysis
- RCC Beam Design
- RCC Column Design
- RCC Circular Column Design
- RCC Footing Design
- Name Plate
- DXF Output
- Pick Member Properties
- Apply Member Properties
- Create Columns
- Divide Member
- Renumber Beams
- Renumber Columns
- Label Member
- Show Beam Loads
- Show Beam Section Properties
- Show Slab Properties
- Member End Forces
- Column Forces
- Mirror
- Center of Mass
- Center of Stiffness
- Print Key Plan
- Print Schedule of Slabs
- Print Schedule of Beams
- Print Schedule of Columns
- Print Schedule of Circular Columns
- Print Schedule of Footings
- Plan View
- Isometric View
- Rotate X+
- Rotate X-
- Rotate Y+
- Rotate Y-
- Message
- Co ordinates
- Floor Level
- Joints On / Off
- Members On / Off
- Supports On / Off
- Slabs On / Off
- Plan / Isometric
- Example