Documentation

• Introduction
• New Project
• Open Project
• Save Project
• Delete Project
• Upload DXF
• New Joint
• Delete Joint
• Edit Joint
• List Joint
• New Member
• Delete Member
• Edit Member
• List Member
• New Joint Load
• Delete Joint Load
• Edit Joint Load
• New U.D. Load
• Delete U.D. Load
• Edit U.D. Load
• List U.D. Load
• New Slab
• Delete Slab
• Edit Slab
• List Slab
• Joint Renumber X
• Joint Renumber Y
• Joint Renumber Z
• Help
• Tutor
• Zoom Window
• Zoom All
• Default Member Size
• Default Member Load
• Joint Offset Y
• Joint Offset Right
• Joint Offset Down
• Joint Offset Left
• Joint Offset Up
• New Support
• Delete Support
• Edit Support
• List Support
• New Point Load
• Delete Point Load
• Edit Point Load
• List Point Load
• New U.I. Load
• Delete U.I. Load
• Edit U.I. Load
• List U.I. Load
• Copy Entire Floor
• Run Analysis
• RCC Beam Design
• RCC Column Design
• RCC Circular Column Design
• RCC Footing Design
• Name Plate
• DXF Output
• Pick Member Properties
• Apply Member Properties
• Create Columns
• Divide Member
• Renumber Beams
• Renumber Columns
• Label Member
• Show Beam Loads
• Show Beam Section Properties
• Show Slab Properties
• Member End Forces
• Column Forces
• Mirror
• Center of Mass
• Center of Stiffness
• Print Key Plan
• Print Schedule of Slabs
• Print Schedule of Beams
• Print Schedule of Columns
• Print Schedule of Circular Columns
• Print Schedule of Footings
• Plan View
• Isometric View
• Rotate X+
• Rotate X-
• Rotate Y+
• Rotate Y-
• Message
• Co ordinates
• Floor Level
• Joints On / Off
• Members On / Off
• Supports On / Off
• Slabs On / Off
• Plan / Isometric
• Example